banner



How High Should My Service Drop Be From My Roof

The National Electric Lawmaking (NEC 230.24(A)) requires that overhead service wires (conductors) exist a minimum of viii feet above a roof, including for a minimum 3 feet in all directions from the edge of the roof, but and so provides four commanded exceptions. One of the exceptions is the almost mutual type of residential overhead electric service type, and then we will start with it. If the service mast is a "through-the-roof" installation, meaning that it only penetrates the roof at the overhang to come down to a meter at the exterior wall below, as in the photograph in a higher place, and then the wires are merely required to articulate the roof by 18 inches.


     There are a couple of further stipulations for this exception to be immune:

  1. The mast must be located within 4 feet of the edge of the roof, so maximum roof overhang is 4 feet.
  2. Non more than 6 feet of service wires are allowed to pass over the roof. This is intended to avoid an installation with wires that run diagonally beyond the roof overhang near the border for an extended distance at the low xviii-inch height.

    The 2nd exception allows a reduction to 3 feet above the roof when the roof pitch is 4/12 (4 inches of ascent for every 12 inches of horizontal run) or more. In that location are no restrictions on the length of service conductors over the roof. The logic behind this exception is that steeply sloped roofs are not probable be be walked on by anyone except workers on the roof.

    Exemption number three allows service conductors fastened to the side of a building below roof level to be exempt from "8 foot clearance up to iii feet from border of roof" dominion to enable attachment to the structure.

    The last exception in the NEC states that areas above roof surfaces that are subject to vehicular or pedestrian traffic must meet the same standards for service usher clearance above the ground for the particular type of traffic, as outlined in NEC 230.24(B). This is an unusual scenario for residential construction, and would actually increment the clearance requirements when there is vehicular traffic.

    For an overview of the clearance requirements between utility pole and house, run across our blog mail What is the minimum overhead electric service drop height/clearance to a business firm? And for swimming pool minimums, run into our blog post What are the clearance requirements for an overhead electric service drop that is direct over or near a  swimming pool?  Also, What is the electric "service point" of a house?

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

Hither's links to a collection of our other blog posts well-nigh ELECTRICAL WIRING:

• Which house appliances demand a dedicated electric circuit?

• Can a short circuit cause a high electric nib?

• Can yous use a light switch for a water heater disconnect?

• When did the requirement for two 20-amp kitchen counter apparatus circuits brainstorm?

• What is the maximum spacing requirement for securing NM-cable (nonmetallic-sheathed cablevision)?

• Is it alright to simply put wire nuts on the stop of unused or abandoned NM-cable or wiring?

• What causes copper wires to turn dark-green or black in an electric console? 

• Is the latest edition of the National Electric Code (NEC) the standard used for the electrical system of new homes?

• What are typical aluminum service entrance wire/cable sizes for the electrical service to a firm?

• Why is information technology unsafe to bail neutral and basis wiring at subpanels?

• When was it first required that neutrals and grounds be separated (not bonded) on any panel past the primary service panel?

• Should I get a lightning rod system to protect my house?

• Why is a strain relief clamp necessary for the string connection to some electric appliances? 

• Does a wire nut connection need to be wrapped with electrical record?

• What is the departure between a UL rating for dry, damp, and wet locations?

• What is three phase electric service?

• What is a reliable way to tell if the electrical service is 3 phase or single phase?

• Tin NM-cable (Romex®) be used to make a string and plug to connect an apparatus?

• What are the requirements for NM-cables entering an electric panel box?

• What is the color code for NM cable (Romex®) sheathing?

• Tin can I remove a 240-volt range receptacle and hard-wire the range?

• Why do some wires in an electric panel have record wrapped around them near their connections?

• Why is undersize electric wiring in a house unsafe?

• Why is bundled wiring in an electric panel a defect?

• What causes flickering or blinking lights in a house?

• What is the voltage rating of a house electrical system?

• Why are onetime electrical components not ever "grandfathered" as acceptable by habitation inspectors?

• What is tinned copper wiring?

• What is a conduit body or condulet?

• How can I detect out the size of the electric service to a house?

• What could cause an extremely loftier electric bill?

• Can quondam electrical wiring get bad inside a wall?

• What are the code requirements for NM-cablevision (nonmetallic-sheathed cable or Romex®) in an attic?

• What is the difference betwixt "grounded" and "grounding" electrical conductors?

• What does it mean when a wire is "overstripped" at a circuit billow?

• What is an open electric splice?

• What are the most common electrical defects plant in a home inspection?

• What is the life expectancy of electrical wiring in a house?

• Do whatsoever pre-1960 houses take aluminum wiring?

• What is the gooey stuff on some of the wire connections in the electric panel?

• How much does it price to rewire a house?

• What is an "open junction box"?

• What are the clearance requirements for an overhead electric service drop that is directly over or near a swimming puddle?

• How unsafe is old electric wiring?

• What is a footing wire?

• What are the most common homeowner electrical wiring mistakes?

• I heard that aluminum wiring is bad. How do yous bank check for aluminum wiring?

• What is "knob and tube" wiring?

    Visit our ELECTRICAL page for other related blog posts on this subject, or get to the INDEX for a complete listing of all our articles.

Source: https://www.howtolookatahouse.com/Blog/Entries/2018/6/what-is-the-minimum-clearance-of-overhead-electric-service-drop-wires-above-a-house-roof.html#:~:text=The%20National%20Electric%20Code%20(NEC,then%20provides%20four%20allowable%20exceptions.

Posted by: howejuserebeaven.blogspot.com

0 Response to "How High Should My Service Drop Be From My Roof"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel